Operation Manual

DJI VISION App Usage

A circle on the map, as shown in Figure 104, indicates a restricted, No Waypoint area. Waypoints cannot be

placed in this area. For more information, refer to “6.2 Flight Restriction of Restricted Areas (P30)”.

To achieve the optimal video transmission quality, the aircraft is set to operate within a 500m-radius area from

Home point.

Tap on a waypoint to open a waypoint properties window. Slide the white dot right to adjust waypoint altitude. The

default altitude is set to 98 feet (30 m) and can be adjusted from 0 to 650 feet (200 m). Tap “OK” to save waypoint

settings. To delete current waypoint, tap

. Modify longitude and latitude value using the input box.

Step 3 Preview a Mission:

Tap “Done” to preview the mission when all waypoints are set. A prompt similar to the one below will appear.

This prompt lists all waypoints and their altitudes. The aircraft will y to each waypoint listed. If there is a difference in

altitude between waypoints, the aircraft will adjust its altitude as it ies between points. When ready, tap “GO” to begin

mission.

Figure 107

Aircraft reacts differently to the “GO” command:

If aircraft is on the ground, the aircraft takes off automatically and ascend 16 feet (5m) then fly to the first

waypoint.

If aircraft is in the air, the aircraft ies to the rst waypoint.

Step 4 Executing Flight Mission

The aircraft ies to each waypoint in numerical order. As it ies, swipe back into the DJI Vision app camera GUI to

control camera tilt and capture photos or video. Tap

to pause the mission during the ight, and aircraft will then start

hovering. Tap

to resume mission. If you wish to regain control of the aircraft, toggle the S1 switch on remote controller

from

(Position-1) to either (Position-2) or (Position-3) to discontinue the current mission.

Step 5 Landing

When all waypoints have been visited, the aircraft will return to its Home point and hover. Regain control of the aircraft

and land it manually. You may also tap

button to initiate “Go Home” procedure. Aircraft will abort current mission,

return to Home point and auto land. When the aircraft is landing automatically, users can control the aircraft’s position

and altitude. Users can start the motors to take off immediately after the motors have stopped following auto landing.

Figure 105

113.94984 22.54074

waypoint1

Longitude

Height

Latitude

Figure 106