Operation Manual
Assembly and Use
16
©
2015 DJI. All Rights Reserved.
Propellers self tighten during ight. DO NOT use thread locker.
Always match marked props with the corresponding motor.
Protective gloves are recommended during propeller assembly and removal.
4.3 Removing the Propellers
(Figure 22) Prevent motor rotation using the included wrench or a
hand, then remove propeller according to the un-fastening instructions.
4.4 Notes
(1) Check that propellers and motors are installed correctly and rmly
before every ight.
(2) Ensure that all propellers are in good condition before each ight.
DO NOT use any ageing, chipped, or broken propellers.
(3) To avoid injury, STAND CLEAR of and DO NOT touch propellers or
motors when they are spinning.
(4) ONLY use original DJI propellers for a better and safer ight experience.
For beginner yers, Phantom 2 Prop Guards are recommended. Contact your authorized dealer or DJI customer
service to purchase if necessary.
5 Preparing the Remote Controller
The Phantom 2 Vision+ Remote Controller is a wireless communication device using the 5.8GHz frequency band.
Remote Controller and Phantom are paired before delivery.
For upgraded remote controller (models: NPVT581, NDJ6 or NRC900), select “Upgrade Version” in Phantom Assistant.
For basic remote controller (models: PVT581, DJ6 or RC900), select “Basic Version” in Phantom Assistant.
The Remote Controller is set to Mode 2 by default. This can be adjusted in the PHANTOM RC Assistant. See Using the
PHANTOM RC Assistant (Page 47) for details. You can also adjust the power of your Remote Controller according to
national regulations. Please refer to Compliance Version Conguration (Page 19).
Compliance Version: The Phantom 2 Vision+ Remote Controller is compliant with CE and FCC (see the FCC ID)
regulations.
Operating Mode: Mode 1 and Mode 2 refer to different channel mappings.
Mode 1: The right stick controls throttle.
Mode 2: The left stick controls throttle.
The Range Extender and Phone Holder are already mounted on the Remote Controller. Twist the Mobile Device
Holder to face outwards and x it in position for mobile device installation.
Large smartphones and tablets are not recommended for the Phone Holder as they do not t.
Preparing the Remote Controller
Figure 22
Figure 23