Manual

ManualsBrandsDJI ManualsHardwarePhantom 2 FPV HUB Kit

PHANTOM 2 FPV HUB Kit Instruction V1.0

PHANTOM 2 FPV HUB kit contains only cables and the FPV HUB to

make connections convenient, easy and thus removing the need to do

soldering when connecting them to an iOSD mini，iOSD Mark II or a DJI

specified wireless video transmission module AVL58. Only 4 cables

require soldering if users opt to use a wireless video transmission that’s

not specified by DJI.

1. FPV HUB, the main connection board used to extend devices.

2. HUB-AVL58 cable, used to connect AVL58 and FPV HUB.

FPV HUB AVL58

3. HUB-iOSD Mark II cable, used to connect iOSD Mark II and FPV HUB.

FPV HUB iOSD Mark II

4. HUB-ZEN cable, used to connect H3-2D gimbal and FPV HUB.

FPV HUB H3-2D

5. HUB-iOSD mini cable, used to connect iOSD mini and FPV HUB.

FPV HUB iOSD mini

6. HUB-VTX cable, used to connect the FPV HUB and other wireless

video transmission module.

Summary of content (5 pages)

PAGE 1
PHANTOM 2 FPV HUB Kit Instruction V1.0 PHANTOM 2 FPV HUB kit contains only cables and the FPV HUB to make connections convenient, easy and thus removing the need to do soldering when connecting them to an iOSD mini，iOSD Mark II or a DJI specified wireless video transmission module AVL58. Only 4 cables require soldering if users opt to use a wireless video transmission that’s not specified by DJI. 1. FPV HUB, the main connection board used to extend devices. 2.
PAGE 2
DJI unspecified wireless video transmission module FPV HUB Connections Choose devices collocation used with FPV-HUB according to required functions. Collocation Functions 1 Wireless video transmission module Video transmitting 2 iOSD mini, Wireless video transmission module OSD, Video transmitting 3 iOSD MARK II, Wireless video transmission OSD, Video transmitting, module Data record For wireless video transmission, the ALV58 is recommended for easy connection, using a HUB-AVL58 cable.
PAGE 3
module, connect it to the FPV HUB via HUB-VTX cable according to pins description of the HUB-VTX cable. GND wire from PHANTOM 2, connect it to the GND port of wireless GND video transmission module. Power wire from PHANTOM 2 provides 1.5A@12V power. Connect it VCC to the VCC port of wireless video transmission module. GND wire of analog video signal, connect it to the VIDEO_GND port of wireless video transmission module.
PAGE 4
the FPV HUB. 3) Please refer to Collocation1 to connect the wireless video transmission module. Notes (1) If using the FPV HUB, the original 4-Pin cable and video cable on PHANTOM 2 will be spared, please remove and clear them out. Make sure the video cable is totally cleared without any copper wire left to prevent short circuit damage. (2) All the connection operations should be conducted when the intelligent battery is powered off.
PAGE 5
to avoid unexpected damage. (9) Make sure the connection is correct when using wireless video transmission module unspecified by DJI. Tips (1) FPV HUB has a resettable fuse for over circuit precaution. The fuse will automatically open to prevent damage if the working current of power consuming devices (except DJI Zenmuse series) goes over 2A or if VCC and GND short circuited.