OSMO Vehicle Mount Quick Start Guide V1.
Disclaimer and Warning Congratulations on purchasing your new DJI product. The information in this document affects your safety and your legal rights and responsibilities. Read this entire document carefully to ensure proper configuration before use. Failure to read and follow instructions and warnings in this document may result in serious injury to yourself or others, damage to your DJI product, or damage to other objects in the vicinity.
Installation 1. Unfold the universal joint by loosening the knob. Screw it onto the base. Then, slide the base lock to the locked position. 1 2 3 2. Place the Vehicle Mount on a flat surface such as the roof of your car. Ensure the suction cups make good contact with the surface and then push down the suction cup levers.
3. Attach the Osmo handle to the Vehicle Mount and then tighten the screw to secure. The position of the Osmo handle can be adjusted by loosening the knob on the universal joint. 1 2 Ensure the base lock is in the unlocked position before unscrewing the universal joint. WARNING 1. Ensure the Vehicle Mount is mounted on a flat and clean surface. Failure to do so may cause the suction cups to perform poorly and result in the Vehicle Mount falling off. 2.
