User guide

Table Of Contents

Appendix

Firmware & Assistant Software Upgrade

Please follow the procedure for software and firmware upgrade; otherwise the NAZA-H might not work

properly.

STEP1 Make sure your computer is connected to the Internet.

STEP2 Please close all the other applications during the firmware upgrade, including anti-virus software

and firewall.

STEP3 Make sure the power supply is securely connected. DO NOT un-plug the power supply until

firmware upgrade has finished.

STEP4 Connect NAZA-H to PC with Micro-USB cable, DO NOT break connection until firmware upgrade

is finished.

STEP5 Run Software and wait for connection.

STEP6 Select InfoSoftware and Firmware.

STEP7 DJI server will check your current software and firmware version, and get the latest software and

firmware prepared for the unit.

STEP8 If there is a software version more up-to-date than your current version, you will be able to click to

download the new version. Please re-install the assistant software follow the prompts

STEP9 If there is a firmware version more up-to-date than your current version, you will be able to click to

update them. Wait until Assistant software shows “finished”. Click OK and power cycle the unit

after at least 5 seconds.

STEP10 Your unit is now up-to-date.

Note:

 After firmware upgrade, please re-configure the NAZA-H using Assistant software.

 If the network or DJI server is busy, try again later with above procedures.

 If firmware upgrade failed, NAZA-H will enter waiting for firmware upgrade status automatically,

please try again with the above procedures.

 You may be asked to register by filling in the contact information before upgrade.