Manual
73
©
2023 DJI All Rights Reserved.
DJI Mini 3 Pro
User Manual
Make sure to follow all the steps to update the rmware, otherwise the update may fail.
The rmware update will take approximately 10 minutes. It is normal for the gimbal to go limp, aircraft
status indicators to blink, and the aircraft to reboot. Wait patiently until the update is complete.
Make sure the computer is connected to the internet during the update.
Before performing an update, make sure the Intelligent Flight Battery has at least 40% power and the
remote controller 20%.
Do not unplug the USB-C cable during an update.
Aftersales Information
Visit https://www.dji.com/support to learn more about aftersales service policies, repair services, and
support.
FAR Remote ID Compliance Information
The aircraft complies with the requirements of 14 CFR Part 89:
•
The aircraft automatically broadcasts Remote ID messages from takeo to shut down. An external
device such as a cell phone or tablet is required to be connected as a location source to DJI mobile
devices without an integrated GNSS system
[1]
, and must run the DJI flight control app such as
DJI Fly in the foreground and always allow the DJI ight control app to obtain its accurate location
information. The connected external device must minimally be one of the following:
a) FCC Certied personal wireless device that uses GPS with SBAS (WAAS) for location services; or
b) FCC Certied personal wireless device with integrated GNSS.
Also, the external device must be operated in a way that does not interfere with the location reported
and its correlation to the operator location.
•
The aircraft automatically initiates a pre-ight self-test (PFST) of the Remote ID system before takeo
and cannot take o if it does not pass the PFST
[2]
. The results of the PFST of the Remote ID system
can be viewed in either a DJI ight control app such as DJI Fly or DJI goggles.
•
The aircraft monitors the Remote ID system functionality from pre-ight to shut down. If the Remote
ID system malfunctions or has a failure, an alarm will be displayed in either a DJI ight control app
such as DJI Fly or DJI goggles.
Footnotes
[1] DJI mobile devices without an integrated GNSS system such as DJI RC-N1, DJI FPV Goggles V2, and DJI
Goggles 2.
[2] The pass criterion for PFST is that the hardware and software of the Remote ID required-data source and
transmitter radio in the Remote ID system are functioning properly.