User's Guide

9
2-6. High Power Output Port (XT30)
The max continuous current is 15 A and the max peak current is 30A. The five
ports are parallel with power input from Port 8 (High Power Input Port).
7. Power Adapter Input Port
Connect the power adapter to the port, connect the power adapter to the AC
power source (100 - 240 V, 50/60 Hz), and then Port 1 can supply power to
the Manifold 2 continuously. Many of DJI’s power adapters are available for
this port. Refer to the Specifications for details.
The following situation is an example to use this port. Connect this port to a
power source, and connect Port 1 to the power port of the Manifold 2. The
Manifold 2 will keep powering on even when replacing the input battery
connected to Port 8 on the Power Distribution Unit.
8. High Power Input Port (XT60)
Connects to a 4S - 6S LiPo battery to supply power to the Manifold 2 and
other devices through Port 2 - 6 on this unit. The max continuous current is
30 A and the max peak current is 60A.
Connect Port 1 and one of Port 2 - 6 to the two power ports on the
Manifold 2 simultaneously to supply power to the Manifold 2
independently.
It is recommended to use the Power Distribution Unit for power
management since the optimal electromagnetic compatibility can
reduce interference to the GPS or Wi-Fi signal from the power
supply.
Connect devices of high power to Port 2 - 6 in sequence according to
their power, from low to high, to avoid potential heat.