User's Guide

11
This recovery button is only available for the Manifold 2-G. When using with
the RST button, the Manifold 2-G can enter Recovery Mode. Refer to System
Image for details.
3. PWR Button
Power button. Press once to power on/off the Manifold 2. Press and hold for
10 seconds to force the Manifold 2 to power off.
4. RST Button
Reset button. Press once to reset the Manifold 2.
5. I/O Port
Connects to the I/O port on the Manifold 2 using the I/O cable.
System Configuration
Perform basic setup in the terminal interface.
Basic Configuration
The Manifold 2 comes with pre-installed Ubuntu 16.04 operating system.
Users can log in with the information below when connecting a monitor with
a HDMI port, mouse and keyboard after powered on.
User name: dji Password: dji
Network Configuration
Access the Internet using a network cable or Wi-Fi (for the Manifold 2-G
only). The Manifold 2 will be assigned with an IP address automatically, if
DHCP service is available on the connected network. Otherwise, run the
following commands to obtain an IP address: