Manual

7
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
The aircraft complies with FCC radiation exposure limits set forth for an uncontrolled
environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure
limits, human proximity to the antenna shall not be less than 20cm during normal operation.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
This remote controller complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End user must follow the specific operating instructions for
satisfying RF exposure compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves
established by the Federal Communications Commission (USA). These requirements set a SAR
limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this
standard during product certification for use when properly worn on the body.
ISED Compliance Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions: (1) This device may not cause interference. (2)This device must
accept any interference, including interference that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :(1)L’appareil ne doit pas produire de brouillage; (2)L’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
This equipment complies with RSS
‐
102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites d'exposition aux radiations CNR
‐
102 établies pour
un environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance
minimale de 20 cm entre le radiateur et votre corps.
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. The portable device is designed to meet the requirements for exposure
to radio waves established by the ISED.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems; where applicable,
antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to remain compliant
with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly
indicated. le dispositif utilisé dans la bande 5150-5250 MHz est réservé à une utilisation en
intérieur afin de réduire le risque de brouillage préjudiciable aux systèmes mobiles par satellite
dans le même canal;le cas échéant, le (s) type (s) d'antenne, le (s) modèle (s) d'antenne et l'angle
(s) d'inclinaison le plus défavorable nécessaire (s) pour rester conforme (e) au p.e. L'exigence
relative au masque d'élévation énoncée à la section 6.2.2.3 doit être clairement indiquée.
These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest
SAR value reported under this standard during product certification for use when properly
worn on the body.
Ces exigences un SAR limite de 1,6 W/kg en moyenne pour un gramme de tissu. La valeur
SAR la plus élevée signalée en vertu de cette norme lors de la certification de produit à utiliser
lorsqu’il est correctement porté sur le corps.
View E-label
Swipe down from the top of the home screen to enter Quick Settings, tap and select
Compliance Info.
查看电子标签
从首页顶部下滑打开快捷面板，然后点击系统设置图标 ，选择认证信息。
CMIIT ID
：
2022AP0287
查看電子標籤
於首頁頂部向下滑動打開快捷面板，然後按下系統設定圖標 ，選擇認證資訊。
E 라벨 보기
홈 화면 상단에서 아래로 밀어서 ‘빠른 설정’을 실행하고 아이콘을 누르고 ‘준수 정보’를 선택하십시오 .
E ラベルの表示
ホーム
画
面の上部から下へスワイプし、クイック設定に入り、 をタッ プして、[ コンプライアンス情報 ] を
選びます。
Voir le E-label
Balayez de haut en bas depuis l’écran d'accueil pour accéder aux Paramètres rapides, appuyez
sur et sélectionnez Informations de conformité.
Visualizar selo eletrônico
Deslize para baixo a partir do topo da tela inicial para abrir as Configurações rápidas, toque
em e selecione Informações de conformidade.
部件名称
有害物质
铅
(Pb)
汞
(Hg)
镉
(Cd)
六价铬
(Cr
+6
)
多溴联苯
(PBB)
多溴二苯醚
(PBDE)
线路板 × ○ ○ ○ ○ ○
外壳 × ○ ○ ○ ○ ○
液晶屏（如有） × ○ ○ ○ ○ ○
金属部件（铜合金） × ○ ○ ○ ○ ○
内部线材 × ○ ○ ○ ○ ○
其他配件 × ○ ○ ○ ○ ○
本表格依据 SJ/T 11364 的规定编制。
○：表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572 规定的限
量要求以下。
×：表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572 规
定的限量要求。（产品符合欧盟 ROHS 指令环保要求）
5150-5250MHz, 仅限室内使用 /Indoor use Only
電波法により W52 は屋外利用禁止です（法令により許可された場合を除く）
KC Compliance Notice
“해당무선설비는 운용 중 전파혼신 가능성이 있으므로 인명안전과 관련된 서비스는 할 수 없습니다 .”
“해당 무선설비는 운용 중 전파혼신 가능성이 있음”
NCC Compliance Notice
取得審驗證明之低功率射頻器材，非經核准，公司、商號或使用者均不得擅自變更頻率、加大功率
或變更原設計之特性及功能。低功率射頻器材之使用不得影響飛航安全及干擾合法通信；經發現有
干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前述合法通信，指依電信管理法規定
作業之無線電通信。低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之
干擾。
應避免影響附近雷達系統之操作。
高增益指向性天線只得應用於固定式點對點系統。
供遙控無人機類似器材遙控器之使用，應符合目的的事業主管機關有關遙控無人機之管理規定。
EU Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device (DJI
Mavic 3 Pro) is in compliance with the essential requirements and other relevant provisions of
the Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available online at www.dji.com/euro-compliance
EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany