User Guide

3. Preparing the Remote Controller

Mounting the WB37 Intelligent Battery

A WB37 battery (excluded) can be mounted onto the

remote controller in the following steps.

1. Push the rear cover release button to the end to open

the rear cover.

2. Insert the WB37 battery into the battery compartment

and push it to the top. There will be a clicking sound to

indicate the battery is installed rmly.

3. Close the rear cover.

To remove the WB37 battery, press and hold the battery release button

and push the battery downward.

Adjusting the Antennas

A prompt will appear in DJI Pilot2 if the transmission signal is weak

during ight. Adjust the antennas to make sure that the aircraft is

in the optimal transmission range.

Lift and adjust the antennas. The strength of the remote

controller signal is aected by the position of the antennas.

Adjust the direction of the external RC antennas and make sure

their flat side is facing the aircraft, so that the controller and

aircraft are within the optimal transmission zone.

Charging time for a WB37 battery with 0% power:

a. When it is mounted on the remote controller and the

internal battery power is 0%: approximately two hours (the

internal battery will be fully charged simultaneously)

b. When it is mounted on the remote controller and the

internal battery power is 100%: approximately 1 hour and

10 minutes

c. When it is inserted into the BS30 battery station:

approximately 1 hour and 20 minutes