User Guide

EN
4
Using M30/M30T
1. Activating and Charging the Remote Controller
Activating and Charging the Internal Battery
Refer to the Matrice 30 Series User Manual for more information
about the internal and external batteries.
Powering on and Activating the Remote Controller
Check battery level: press once.
Power on/o: press and then press and hold for two seconds.
The remote controller needs to be activated before using for the
rst time. Follow the prompts to activate.
Low
High
The remote controller cannot be powered on before activating the
internal battery. The battery level LEDs start to ash to indicate that
the Internal battery is activated.
Make sure to use the included USB-C to USB-C cable for optimal
charging.
It is recommended to use the DJI BS30 Battery Station for
charging. Otherwise, use a certified USB-C charger with a
maximum rated power of 65 W and maximum voltage of 20
V such as the DJI 65W Portable Charger.
Fully discharge and charge the remote controller every three
months. The battery depletes when stored for an extended
period.
The battery station will automatically warm up a TB30 battery
to 18° C (64.4° F) before charging if the temperature of the
battery is lower than 10° C (50° F) when inserted.
Refer to the BS30 Intelligent Battery Station User Guide for
more information about the charging and the LEDs.
2. Charging the TB30 Batteries and WB37 Battery
1. Connect the battery station to a power outlet using the AC
power adaptor cable.
2. Press the power button once to power on the battery station.
3. Insert the TB30 batteries and WB37 battery (excluded) into the
battery ports to start charging. For the TB30 batteries, make
sure the charging mode is set to the correct mode.
1. Connect the BS30 Intelligent Battery Station to a power
outlet using the AC power adaptor cable.
2. The internal battery must be charged for activation
before using for the first time. Connect the battery
station and the remote controller USB-C ports using a
USB-C to USB-C cable. It takes approximately 2 hours
to fully charge the remote controller internal battery.
Storage Mode: Each battery pair is charged to 50% in
sequence and kept at 50% after charging. *
Ready-to-Fly Mode: Each battery pair is charged to 90% in
sequence and kept at 90% after charging. *
Standard Mode: Each battery pair is charged to 100% in
sequence.
* The battery station should be powered on to maintain the
battery level in Storage Mode and Ready-to-Fly Mode.