MATRICE 300 RTK Maintenance Manual v1.0

6
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK
Maintenance Manual
Checklist When Powered On
Antennas
1. All the antennas on the aircraft and remote controller are tightened rmly and free
of damage. They are in a place that will give the propellers proper clearance.
Gimbal
(Payload)
1. The gimbal appears intact and can rotate smoothly in all the three axes.
2. The lens is clean.
Radar
(Payload)
1. There is no blockage. The shell of the radar has no damage. The mounting
bracket is secure and in good condition.
Remote
Controller
1. The control sticks are centered in neutral position, with no foreign object such as
sand and soil, and can smoothly reach full ranges of motion in all channels.
2. The screen on the remote controller is clean and dry.
Damping Plate
1. The dampeners and gimbal anti-drop rope are not damaged. The damping plate
has no crack or split. The gimbal connector is secure and cannot be rotated in
the opposite direction after the gimbal is installed.
Infrared
Sensing and
Vision Systems
1. There is no blockage in the working range of the Infrared Sensing and Vision
Systems and auxiliary lights, especially when using a non-DJI payload or
accessory.
2. Check the lenses or glass of the Infrared Sensing and Vision Systems and
auxiliary lights.
a. Make sure there are no stickers or any other obstructions over the Infrared
Sensing and Vision Systems.
b. Clean the lenses and glass with a dust-free cloth if there is any moisture,
ngerprint, or dirt.
c. Contact DJI Support if there is any damage to the lenses of the Infrared
Sensing and Vision Systems.
Emergency
Supplies
1. Spare USB-C cables
2. Two pairs of spare landing gears
3. Two pairs each of spare CW and CCW propellers
4. Spare microSD cards
5. Screwdrivers, screws of all types used, cable ties, tape, a dry and soft cloth
6. A multimeter
7. A case to store emergency supplies
※ It is recommended to replace the propellers only in an emergency situation during operations. After the emergency
ight is over, please contact DJI technical support or an authorized agent for overhaul as soon as possible.
Type Essentials
Remote
Controller
1. Conrm the control stick mode (Mode 1/2/3), and check in the control stick
calibration page in the app if the proportion of the control lever is correct.
2. The remote controller has sufcient power and the battery is rmly installed.
3. Conrm that the channel used is automatic or custom, and then choose the
operation frequency and channel according to the signal to noise ratio.