MATRICE 300 RTK Maintenance Manual 2020.05 v1.
Searching for Keywords Search for keywords such as “battery” and “install” to find a topic. If you are using Adobe Acrobat Reader to read this document, press Ctrl+F on Windows or Command+F on Mac to begin a search. Navigating to a Topic View a complete list of topics in the table of contents. Click on a topic to navigate to that section. Printing this Document This document supports high resolution printing.
Contents Introduction 4 Disclaimer 4 Safety Guidelines 4 Flight Condition Requirements 4 Storage and Transportation 5 Firmware Updates 5 Inspection and Maintenance 5 Routine Inspection 5 Regular Maintenance 8 After-Sales Service 16 Warranty Policy 16 Repair Channel 16 Appendix 17 Maintenance Record 17 © 2020 DJI All Rights Reserved.
Introduction This Maintenance Manual offers guidelines to help you in the daily upkeep and maintenance of your aircraft. A record table is also included to help you keep track of the maintenance records throughout the product lifecycle. This document will focus on the maintenance instructions and the notes, cautions, and warnings during use. Read the User Manual and Maintenance Manual carefully to optimize your user experience.
MATRICE 300 RTK Maintenance Manual Storage and Transportation There are safety requirements for the storage and transportation of the Intelligent Flight Batteries. Please strictly follow these Intelligent Flight Battery Safety Guidelines. Firmware Updates To optimize your experience, it is recommended to keep the firmware of the aircraft and remote controller up to date before each flight. Refer to the User Manual for instructions on running a firmware update.
MATRICE 300 RTK Maintenance Manual Antennas 1. All the antennas on the aircraft and remote controller are tightened firmly and free of damage. They are in a place that will give the propellers proper clearance. Gimbal (Payload) 1. The gimbal appears intact and can rotate smoothly in all the three axes. 2. The lens is clean. Radar (Payload) 1. There is no blockage. The shell of the radar has no damage. The mounting bracket is secure and in good condition. Remote Controller 1.
MATRICE 300 RTK Maintenance Manual Battery 1. All batteries, including Intelligent Flight Batteries and remote controller batteries, are fully charged. 2. It is recommended to charge and discharge the battery by following the standard instructions before flight if the battery is stored for a period longer than one month. 3. The Intelligent Flight Batteries are firmly installed. 4. Check the battery level and voltage of each battery cell in the battery page in the app to make sure they are normal.
MATRICE 300 RTK Maintenance Manual Flight Test Checklist Type Essentials Flight Test 1. Make sure that there are no potential safety hazards or people within 5 m of the aircraft. 2. Make sure that the satellite count is more than 10 and there is sufficient light. Start video recording. 3. In P-mode, perform CSC to make the motors spin at an idle speed on the ground. Push the control sticks in each direction lightly to test. Then push the throttle stick down to the bottom until the motors stop. 4.
MATRICE 300 RTK Maintenance Manual 1. Regular maintenance items 2. Updates and calibration Routine 3. Deep cleaning Maintenance 4. Components replacement due to wear and tear 1. Regular maintenance items 2. Update and calibration 3. Deep cleaning Deep 4. Component replacement Maintenance due to wear and tear 5. Core component replacement Factory service mandatory Total flight time is 400 hours, or the product has been used for 12 months.
MATRICE 300 RTK Maintenance Manual Motor Air Filters 1. Air filters are not loose or damaged. 2. If they are loose or damaged, return to the factory for repair. Propellers 1. Check the propellers for visible deformation, severe wear, nicks, and cracks, and if there are any foreign materials. 2. Clean the propellers with a dry soft cloth. 3. Replace the propellers immediately if visible deformation, severe wear, nicks, or cracks occur. ※ 4.
MATRICE 300 RTK Maintenance Manual Screws Landing Gear Base 1. All the screws on the aircraft body are tightened, especially the screws connecting the motor and the carbon tube. 1. Screws are secure. 2. There is no damage or cracks. Frame Arms 1. The 28 screws on the four frame arms are secure. 2. The arm junctions are not damaged or cracked. 3. Grab the carbon tube and shake the arm slightly to check if there is no obvious shake. Frame Arm LEDs 1.
MATRICE 300 RTK Maintenance Manual Data Ports Heat Dissipation Vents 1. Clean the foreign objects near the ports with a gauze. 2. If the port is in use, disconnect the cable, then check if there are foreign objects in the port with the help of a light. 3. Remove the foreign objects such as small pieces of stones and pieces of paper in the port using tweezers. 4. Clean the gluey foreign materials in the port with a gauze. 5.
MATRICE 300 RTK Maintenance Manual Infrared Sensing and Vision Systems Infrared Sensing and Vision System Lenses, Auxiliary Lights, and Beacons Auxiliary Lights 1. Clean the lenses with a soft cloth. 2. Lenses are not loose and have no cracks. 3. The auxiliary lights and beacons are not loose and cracked. Top View Bottom View Beacons Top View Bottom View Battery Battery Maintenance Conditions Maintenance is required when any of the events below occur. 1. Every 50 cycles. 2.
MATRICE 300 RTK Maintenance Manual Standard Charge and Discharge Operation Instructions 1. Charge the battery to 100% and leave the battery stationary for more than 24 hours. 2. Install the battery into the aircraft before flight. If the remaining power level is less than 20%, land the aircraft and remove the battery. 3. Leave the battery stationary for more than six hours. 4. Charge the battery to 100% power level. 5. Repeat the above steps. Battery Replacement Standard 1.
MATRICE 300 RTK Maintenance Manual Health Management System Users can view the status of each module and upload the log with abnormal status in the Health Management System (HMS) page in the DJI Pilot app. 1. Enter the HMS page in DJI Pilot. 2. The health condition of each module of the connected device will be displayed onscreen. 3. If any module is abnormal, tap to view the warning message. © 2020 DJI All Rights Reserved.
MATRICE 300 RTK Maintenance Manual 4. Tap the warning message to view the help document for troubleshooting. If the abnormal status still exists after check by following the document, users can upload the log and contact DJI Support for help. 5. View the error records and check if there are frequent error prompts or critical warnings. If the problem cannot be solved, contact DJI Support. Firmware Update Make sure that firmware of the product and its relevant products are all up to date.
Appendix Maintenance Record Maintenance Record Table Maintenance Maintenance Items Date Total Flight Time (hours) Maintainer Signature (hours) □ Vision System Calibration □ Aircraft Body Structure □ Firmware Update □ Batteries □ Core Components Replacement □ Propulsion System □ HMS □ Flight Controller □ Vision System Calibration □ Aircraft Body Structure □ Firmware Update □ Batteries □ Core Components Replacement □ Component Replacement Due To Wear and Tear Maintenance Date M
Maintenance Record Table Maintenance Maintenance Items Date Total Flight Time (hours) Maintainer Signature (hours) □ Vision System Calibration □ Aircraft Body Structure □ Firmware Update □ Batteries □ Core Components Replacement □ Propulsion System □ HMS □ Flight Controller □ Vision System Calibration □ Aircraft Body Structure □ Firmware Update □ Batteries □ Core Components Replacement □ Component Replacement Due To Wear and Tear Maintenance Date Maintenance Items (hours) Ma
DJI Support http://www.dji.com/support This content is subject to change without prior notice. Download the latest version from https://www.dji.com/matrice-300 Copyright © 2020 DJI All Rights Reserved.
