MATRICE 300 RTK - Known Issue List v3.0

M300 RTK Known Issue List
http://www.dji.com/matrice-300
Copyright © 2020 大疆创新 版权所有 11
9.
When taking a screen
recording on the Smart
Controller Enterprise, you
cannot record the sound.
Sound recording will be supported in later
firmware versions.
Starting from RC
version
v02.02.01.02, you
can take screen
recording with
sound.
10.
In Mapping/ Oblique/
Linear Flight Mission mode,
the camera is not taking
photos during the flight.
Please confirm that the gimbal camera is
connected to the 1st gimbal port of M300 RTK.
In Mapping/Oblique/Linear Flight Mission
mode, only the payload connecting to 1st
gimbal port can take photos.
Note: 1st gimbal port is the one on the right
side when looking at the drone from the front.
In RC version
v02.02.01.02, there
will be a notification
on the Prepare to
Fly page reminding
you that ”No
payload detected
for Gimbal 1”,
because in a
survey mission only
the payload on the
1
st
gimbal can take
photos.
11.
After updating Pilot App
from 1.8.0R to 1.9.0, the
aircraft cannot take off.
**Note, the Pilot app for the
M300RTK should not be
updated to 1.9.0. The RC
should be updated which
will update the Pilot app to
1.9.0R.
Please contact DJI support to solve this issue.
Note: M300 RTK need to work with specific
Pilot versions that can be found and
downloaded on this page:
https://www.dji.com/downloads/djiapp/dji-pil
ot
Starting from
aircraft version
v02.02.01.02,
installing the wrong
Pilot version will not
make the aircraft
unable to take off.
But please still keep
using the correct
Pilot version for
M300 RTK.
12.
In mission flight mode, when
pausing a mission, the voice
notification is in Chinese.
This issue will be solved in later firmware
versions.
Solved in RC version
v02.02.01.02