Manual
Table Of Contents
- Legends
- Product Profile
- Aircraft
- Intelligent Battery Charging Hub
- Intelligent Battery
- Gimbal Camera
- Remote Controller
- Preparing the Remote Controller
- Starting and Activating the Remote Controller
- User Interface
- Video Transmission
- Remote Controller LEDs and Alert
- Charging the Remote Controller and Checking the Battery Level
- Linking the Remote Controller and Control Stick Modes
- Buttons Overview
- Flight Mode Switch (N/S/F)
- Calibrating the Compass
- HDMI Settings
- Dual Control Mode
- DJI Professional Ecosystem
- DJI Pilot 2 App
- Flight
- Appendix
- Appendix
DJI Inspire 3
User Manual
76
©
2023 DJI All Rights Reserved.
Linking the Remote Controller and Control Stick Modes
Linking the Remote Controller
The remote controller is already linked to the aircraft when it is purchased together as part of
a combo. Otherwise, follow the steps below to link the remote controller and the aircraft after
activation.
1. Power on the aircraft and the remote controller.
2. Run DJI Pilot 2 and tap Link Remote Controller to link. The status LED of the remote
controller will blink blue, and the remote controller will beep during linking.
3. Press and hold the power button on the aircraft for at least five seconds. The aircraft
power indicator will blink and will beep twice to indicate linking has started. When linking is
successful, the aircraft rear indicators will blink green while the remote controller will beep
twice, and the remote controller status LEDs will turn solid green.
• Make sure the remote controller is within 50 cm (1.6 ft) of the aircraft during linking.
New database for safty available
Prepare To Fly
Prohibited areas
Limit fly
Fire Rescue
Traffic Police Brigade
Academy
Album
Air Line
Remote Controller Linking