FlameWheel450 User Manual V 2.1 2013.03.13 Revision www.dji-innovations.com ©2012 DJI Innovations. All Rights Reserved.
Disclaimer Read this disclaimer carefully before using FlameWheel450. By using this product, you hereby agree to this disclaimer and signify that you have read them fully. FlameWheel450 is an excellent multi-rotor. With a good autopilot, it will even offer tremendous flight features for low altitude flight working in restricted space.
Contents Disclaimer.......................................................................................................................2 F450 Profile ....................................................................................................................2 Contents .........................................................................................................................3 Product Usage Cautions.......................................................................................
In Box Top Board 450FBT ×1 Bottom Board 450FBB ×1 Frame Arms 450FAC ×2 Frame Arms 450FAW ×2 10in Propeller 450P10×2 8in Propeller Pairs 450P08×2 Pairs Motors 450MOT ×4 ESC 450ESC ×4 + Screws 450-M3×8 ×16 U 15A V OPTO W Screws 450-M2.5×6 ×24 Magic Strap 450MSX ×1, Battery Band 450BBX ×1 Power Line Pair 450PLP ×1, Small Wrench 450SW ×1 ©2012 DJI Innovations. All Rights Reserved.
Tools Needed 2.0mm Hex Wrench For frame and motors installation. Screw Glue For fastening screws. Nylon Cable Tie Scissors For binding devices and wires. Diagonal Cutting Pliers Foam Double Sided Adhesive Tape For fixing receiver, controller and other modules. Soldering-iron & wires For connecting ESCs’ power cables to bottom board. ESC Wiring ESC ESC Power Pads ESC ESC To Battery Important Please solder ESCs to power pads on bottom board as the figure shows.
Assembly S crew M2 . 5x6 2 1 Top board 3 S crew M3x8 4 Bottom Board Step 1 Install bottom board Step 2 Install autopilot system Install screws by appropriate force to prevent breaking threads. Use adequate screw glue for installing screws. Step 3 Install motors, ESCs Please wire neatly. Make sure wires will not be cut by frame boards and propellers. Smooth out the boards edge if necessary.
ESC Sound Introduction ESC State Sound Ready ♪1234567 Throttle stick is not at bottom BBBBBB… Input signal abnormal B--------B--------B… Input voltage abnormal BB---BB---BB---BB… Tips: DJI ESCs are specially designed for multi-rotors. When use with DJI autopilot systems, you do not have to setup any parameters or calibrate travel range.
