Owner's Manual

7
© 2021 DJI All Rights Reserved.
Operation
Powering On/O
Press the power button once to check the current battery level. Recharge before using if the battery level is too low.
Press once then press again and hold to power the motion controller on or o.
LED1 LED2 LED3 LED4 Battery Level
Battery Level > 80%
75% < Battery Level ≤ 80%
63% < Battery Level ≤ 75%
50% < Battery Level ≤ 63%
38% < Battery Level ≤ 50%
15% < Battery Level ≤ 38%
8% < Battery Level ≤ 15%
0% < Battery Level ≤ 8%
Charging
5V, 1A
The battery level LEDs display the power level of the battery during
charging and discharging. The statuses of the LEDs are dened below:
LED is on.
LED is ashing.
LED is o.
Use a USB-C cable to connect a charger to the USB-C port of
the motion controller. It takes approximately 2.5 hours to fully
charge the motion controller.
The table below shows the battery level during charging.
LED1 LED2 LED3 LED4 Battery Level
0% < Battery Level ≤ 50%
50% < Battery Level ≤ 75%
75% < Battery Level < 100%
Fully charged