User Manual

Table Of Contents

Flight Test

Step1: Ensure the batteries are fully charged for the transmitter, GCU and all the other devices on your

aircraft.

Step2: Make sure all connections and wirings are in good condition.

Step3: Toggle on the switch.

Step4: Make sure to adjust the Roll axis of the gimbal to be level.

Step5: Power on the gimbal and wait for self-testing to begin. The Roll axis will rotate first, and then the yaw

and pitch axes will rotate quickly at the same time.

Step6: After self-testing, the camera lens will point to the aircraft nose direction and the three axes of the

gimbal should be in the condition as the above diagram shows.

Step7: The gimbal will enter initialization, at this time the three axes will rotate very slowly.

Step8: The gimbal is at a standstill after initialization and ready for use.

Step9: Toggle the Working Modes switch on your transmitter, making sure it is working properly.

Step10: Toggle the Working Modes to the Non orientation-locked, FPV Mode (Reset), Orientation-locked

respectively, and then try to push your sticks lightly in Roll, Tilt and Pan modes to see if your gimbal

moves to the corresponding direction. If not, return to the ‘Setting the Working Mode Switch’ section

to correct your settings.

Note:

If the gimbal is abnormal after initialization, please refer to the

Trouble Shooting

Appendix