User Manual

©2013 DJI Innovations. All Rights Reserved.
14
The Video Signal Transmission
A wireless video transmission module is required for the video signal to access remotely.
Wireless Video
Transmission Module
Air End
Disconnected
Video Signal(Yellow:AV)
GND(Black: )
Power
Video Signal
GND
Gimbal Video Signal Cable
Video Signal Port
+ -
Connect to a battery to
supply power for the wireless
video transmission module
Step1: Solder the Power/Video Signal/GND cables to a wireless video transmission module (Air End) respectively.
Step2: Plug the gimbal video signal cable head into the GCU Video Signal Port.
Notices:
 Make sure to connect the Wireless Video Transmission module to the GCU before powering on.
 The standard gimbal video signal cable is recommended.
 Make sure you solder the gimbal video signal cable to the wireless video transmission module correctly.
Ensure the cables are insulated, to prevent a short circuit.
Video Signal Cable(AV)
GND Cable
 Please refer to the user manuals of the wireless transmitter module to supply power for it, since the GCU
cannot provide power for it.
Tips:
 The following diagram shows how the video signal transmits with the gimbal working.
 If the video signal access fails, please check each step.
Camera
AV
Gimbal
GCU
G8
AV signal
Wireless video
transmission
module
Air end
Video
transmission cable
8-Pins cable
Gimbal Video
Signal Cable
Wireless video
transmission
module
Ground end
Wireless signal
Monitor
AV input
5.8G/2.4G/1.2G
Self-prepared by user
AV signal
AV signal
AV signal