User Manual

Ronin-S

User Manual

Solid yellow: external focus motor detected without travel calibration.

Single yellow blinking: external focus motor is being travel calibrated.

Solid green: connected to a camera with electronically controlled focus supported,

or connected to an external focus motor with travel calibration complete.

Single green blinking: external focus motor’s a-point end is set.

Double green blinking: external focus motor’s a-b-point ends are set.

5. CANPort(5V)

Used to connect a wireless receiver.

6. 8-pin Contact

Used for power supply and transmitting control command data.

Installation

There are two 8-pin ports located on each side of the gimbal. The focus wheel is mounted

on one side by default, but can also be mounted to the other side. To mount the focus

wheel to the other side, remove the protector from the port rst.

18 17 16 15 14 13 12 11 10 9

17 16 13 9

Please note that other Ronin-S accessories can be mounted to the 8-pin port. Use the

protector when the port is not in use.