User Manual
Ronin-S
User Manual
©
2018 DJI OSMO All Rights Reserved.
19
General
You can change the mounting mode in between Handheld and Car Mount to best suit
your shooting plan.
You may also switch in between different user proles directly. The User 1, 2 and 3 proles
provide different default settings for SmoothTrack, Control Settings and Auto Tune.
SmoothTrack Control Settings Motor Parameters
Speed Deadband Sensitivity Status Deadband Max Speed Smoothing Auto Tune Grade
User 1
Pan Axis Low Medium Low On Medium Medium Medium
MediumTilt Axis Medium Low Low On Medium Medium Medium
Roll Axis Low Medium Low Off Medium Medium Medium
User 2
Pan Axis Low Medium Low On Medium Medium Medium
MediumTilt Axis Medium Low Low Off Medium Medium Medium
Roll Axis Low Medium Low Off Medium Medium Medium
User 3
Pan Axis High Low High On Low High Low
Medium
Tilt Axis High Low High On Low High Low
Roll Axis High Low High Off Low High Low
Motor Pause can temporarily disengage motors of the Ronin-S so that you can swap your
lenses, change the cameras battery or just take a break after shooting. The Ronin-S will
recenter after unpausing the motors automatically.
Tapping the Recenter button will get the gimbal back to its center position on all three axes.
More
Tapping the Restore Gimbal Setup will restore the applied user prole to default settings.
Tapping the Balance Test, the Ronin-S will check the balance status and provide a score
for each axis. Ensure there is no obstruction of the gimbal before balance testing.
System Calibration
Use only if you notice drift on any of the axes. To calibrate the system, make sure the
gimbal is completely steady, preferably sitting on an even at surface. Be sure the camera
can rotate 90° with the lens pointing straight forward, without any interference from any
wires. Select Calibrate System and let the process nish before picking up the Ronin-S.
System Settings