User Manual
Ronin 2
User Manual
©
2017 DJI OSMO All Rights Reserved.
27
Endpoint: Limits the gimbal’s rotation range by setting the endpoint during controller
input.
Test Endpoint: Allows testing of the pan and tilt endpoints. Ensure the camera is
unobstructed before tapping the test buttons.
The default endpoint settings for pan axis are set to 180°, which means there
is no endpoint for the pan axis, allowing it to rotate 360° continuously.
2. Channel
The channel indicator provides feedback during remote operator conguration. Pan,
tilt, and roll can have channels reassigned. Each axis can also be reversed.
System Settings
Profile
General
More
Settings
Remote Freq.
Bind Remote
2.4HzStart
ON
Axis Mode
3-axis
Calibrate System
60%
212
0º
Speaker
1. General
Calibrate System: Use only if you notice drift on any of the axes. To calibrate the
system, place the Ronin 2 on the Grip and make sure it is completely steady. Be
sure the camera can rotate 90° with the lens pointing straight down, without any
interference from any wires. Select Calibrate System and let the process nish before
picking up the Ronin 2.
Bind Remote: Select to bind with a remote controller.
Remote Freq.: The remote controller can work on both 2.4 GHz and 5.8 GHz Wi-Fi
frequencies. Switch the operating frequency if serious interference is detected.
Speaker: A built-in speaker comes with the Ronin 2, and there will be sound alerts
when powering the gimbal on or off or when an abnormal system status is detected.
The speaker can be switched off via the built-in screen for quieter shooting scenarios.
Axis Mode: Choose between 3-Axis and Pan Lock mode.
2. Prole
The user can save the custom motor congurations or reset to default settings.