User Manual

Ronin 2 User Manual
©
2017 DJI OSMO All Rights Reserved.
25
2. More Settings
Tilt
Pan
+0.0+0
Gimbal Trim
Set power-on position
Basic
More
Motor
Balance test
60%
212
0º
Set the Power-on Position: It is not necessary to set the
power-on position if there is no special requirement. To set
the power-on position, adjust the pan position as needed,
and then press the OK button to conrm. The Ronin 2 will
record this new position and the pan axis will stay at the
recorded position when restarted.
Gimbal Trim: To ne-tune the pan or tilt axis. The default
value is 0, which means the motor is at the center position
and it is not necessary to change.
Balance Test: The pan, tilt, and roll axes will rotate automatically
to check the balance status after selecting Balance Test.
Ensure there is no obstruction of the gimbal before balance
testing. Do not perform a Balance Test if the gimbal is set to
Recenter mode.
Pan
Tilt
Roll
SmoothTrack
Push Pan
OFF
SmoothTrack
ON
20
Speed
5
Deadband
20
Accel
60%
212
0º
SmoothTrack Settings
The settings for the pan, roll, and the tilt axes can be
independently adjusted.
Push Pan (Push Tilt): Enable Push Pan or Push Tilt to allow
the pan and tilt axes to be adjusted by hand when the
Ronin 2 is turned on.
Speed: The speed will determine how fast the camera will
travel while translating a pan, roll, or tilt movement.
Deadband will determine how much movement the gimbal
will tolerate prior to translating the camera’s pan, roll, and
tilt.
Acceleration determines how closely the camera will follow
the translated pan, tilt, and roll movement.