User Manual

ManualsBrandsDJI ManualsProfessional VideoRonin 2 3-Axis Handheld / Aerial Stabilizer Basic Combo

Ronin 2

User Manual

Stiffness: Select the mounting mode prior to adjusting the Stiffness value. The motor

stiffness adjustment allows you to ne-tune the amount of power that is applied by the

motors as they react and balance the weight on each axis. Please make sure you leave

an extra margin for this setting to ensure stability at all times. For example, if the Pan axis

starts to shake at a stiffness of 40, then lower the value to 32. When shooting in Handheld

mode, if the stiffness value set for the roll axis is 20, but the roll axis shaking affects

the footage, that means the stiffness value is too low to provide optimal stability. Try

increasing the stiffness value to 30.

Strength: It is recommended to leave this setting as default. The motor strength

adjustment allows you to minimize Ronin 2’s attitude error. This parameter affects how

quickly the Ronin 2 will react to changes in orientation. If you see any unusual attitude

errors (more than 1 in the readings), you may minimize it by increasing the corresponding

motor’s strength. However, increasing strength too much may also cause the Ronin 2 to

over adjust its orientation and induce shakiness. When the Strength value is set to 10, and

the pan axis cannot stop immediately after a fast rotation, try to decrease the value to 6.

Filter: This setting can ease high-frequency vibrations of the Ronin 2. When the Ronin 2 is

vibrating at a high frequency, you may experience numbness while touching the gimbal

motors of each axis. In such instances, it is recommended to lower the Filter settings.

Control: It is recommended to leave this setting as default. Control can guide the Ronin 2

to better handle low-frequency vibrations. If your Ronin 2 vibrates at a visible range, you

can suppress it by increasing Control. When the vibration persists at low frequency, then

decrease Control. Adjusting Control to optimal settings may take readjustment.

Payloads (kg)

Stiffness Strength Filter Control

Pan Tilt Roll Pan Tilt Roll Pan Tilt Roll Pan Tilt Roll

0 10 6 10 10 10 10 30 45 45 26 28 28

0-2 kg 25 20 20 10 10 10 30 45 45 26 28 28

2-4 kg 35 30 30 10 10 10 30 45 45 26 28 28

4-6 kg 40 40 35 10 10 10 30 40 40 26 28 28

6-8 kg 45 45 40 10 10 10 25 35 35 26 28 28

8-10 kg 50 50 40 10 10 10 25 35 35 26 28 28

10-12 kg 55 55 45 10 10 10 20 30 30 26 28 28

12-13.6 kg 60 55 45 10 10 10 20 25 25 26 28 28

Remarks

The values above

are for reference.

You can adjust

the value within

a value of 10 as

needed.

It is recommended

to use default

settings.