User Manual

Charging the Osmo Mobile 2

To charge the Osmo Mobile 2, connect a USB adapter (not included) to the Charging port

using the provided power cable. During charging the battery level indicators blink to indicate

the current battery level. The battery is fully charged when the battery level indicators turn

solid white. With the battery fully charged, the Osmo Mobile 2’s max run-time is 15 hours*.

It is recommended to use a USB charger of 5V/2A and above. If the current of the charger is less

than 5V/2A, please make sure it meets the USB BC 1.2 standard. Otherwise, it may cause damage.

Charging Time: 2 hours (when charging at 2 A)

Mounting and Balancing a Mobile Phone

Only mount and balance a mobile phone while the Osmo Mobile 2 is powered off.

Mounting the Mobile Phone Horizontally

1. Place the mobile phone in the mobile phone holder while pulling the sides of the

holder outwards, then release the sides of the holder so they hold phone in place. It is

recommended that you position the mobile phone close to the tilt motor.

* Max run-time was tested with the gimbal balanced

and held steadily. This value should be taken for

reference only.

Battery Level Indicators