User Manual

©2013-2014 DJI Innovations. All Rights Reserved 43 |
and the signals from the mapped Receiver
channels will be ignored.
You can use F4 for switching the video
channel of iOSD Mark II, then map D4 to a
Receiver channel.
IOC
IOC function of the Controller Unit,
unmapped.
Click “Unmapped” button to map IOC to a
Receiver channel. It is recommended to use a
3-position switch channel.
Go Home
One-Key Go Home function of the
Controller Unit, unmapped.
Click “Unmapped” button to map Go Home to
the Receiver channel. It is recommended to
use a 2-position switch channel.
Gear
Intelligent Gear function of the Controller
Unit, unmapped.
If you enable the Gear function in Assistant
Software, then the F1 is used for the gear
control of S800 EVO landing.
H3-2D
H3-2D function of the Controller Unit,
unmapped.
Click “Unmapped” button to map H3-2D to a
Receiver channel. It is recommended to use a
Knob switch channel, which is only used for
H3-2D pitch control.
The Pitch and the H3-2D channels can be used at the same time. The Pitch is for the pitch control
of servo gimbal, and the H3-2D is for the pitch control of H3-2D gimbal
Recommended Mapping for Futaba Transmitter (Mode 2) User
Controller Unit Channel
Receiver Channel
Recommended Transmitter Switch
A
Channe 1 (AIL)
Joystick J1
E
Channe 2 (ELE)
Joystick J2
T
Channe 3 (THR)
Joystick J3
R
Channe 4 (RUD)
Joystick J4
U
Channe 7 (AUX5)
3-Position switch, e.g. SG
K1~K6
Channe 5 (GEAR)
Knob switch, e.g. LD, RD
Pitch
Channe 6 (Vpp)
Knob switch, e.g. LD, RD
D1/D3/D2
----
----
D4
Channe 9 (AUX1)
2-Position switch, e.g. SF
IOC
Channe 10 (AUX2)
3-Position switch, e.g. SG
Go Home
Channe 11 (AUX3)
2-Position switch with spring back function, e.g. SH