User Manual

4.2 Servo Gimbal function

Connect the servos of your gimbal to the Controller Unit as the fig. below，roll servo connects to F3 port and

pitch servo connects to F2, and configure in Advanced->Gimbal page in the Assistant software. No Receiver

channel is asked to be mapped for the F2 or F3 port if gimbal function is enabled in the Assistant Software.

Note: Even you map Receiver channels to F3 and F2 (Which are shown as D3 and D2 in the Assistant Software

-> Channel Mapping), the F3 and F2 will not give output signals from the mapped Receiver channels.

Pitch

Roll

4.3 Gear function

Once enable the Intelligent Gear function, the gear is default down on the ground or in case of emergency (e.g.

motor failure tolerance, auto landing); you can control it to be up or down by a switch when the aircraft altitude

is above 5m during flight.

Please configure in the Advanced->Gear page in the Assistant software. Connect the landing gear of S800 EVO

to the Controller Unit as fig. below.

(1) Make sure to enable and configure the Intelligent Gear function in the Assistant software first,

and then connect the gear to the F1 port.

(2) The Gear channel is required to be mapped with a channel on Receiver if the Intelligent Gear

function is enabled in Assistant Software, and the F1 port will give outputs for retracting control.

(3) Once you map the Gear channel, F1 port will give output signals from the controller for retract

control. Otherwise, even the Intelligent Gear function is enabled; F1 will give output from D1 (it’s

necessary to map the D1 channel with a channel on Receiver as your demands).

4.4 Attitude Control When One Motor Output Fails

For Hexa-rotor, including Hexa-rotor I, Hexa-rotor V, Hexa-rotor IY and Hexa-rotor Y, the aircraft with A2 flight

control system is attitude controllable when one motor output fails.

Select Course lock or home lock mode for flying the aircraft into a safe area to land when the aircraft is

far away or the attitude can’t be recognized.