User Manual

3 Protection Functions Setting

Set protection in the Assistant software ->Advanced page. FailSafe and Low voltage protections are required.

3.1 FailSafe

FailSafe works when the Transmitter (TX) signal is lost, the flight control system will automatically control the

aircraft to reduce injuries or damage.

signal

Descriptions

Home

Point

(HP)

≥

30secs later after power on; 10secs later after ≥6( or no Red LED);

Motors have been started; auto-record the position as home point at the first time

the throttle stick is raised.

FailSafe

Flight control system can automatically control the aircraft after Transmitter signal is

lost. It should be set in Assistant software->Advanced->F/S, while Hover, Go-Home or

Alt Go-Home is optional. Additionally, a Go-Home switch can be enabled.

One-Key

Go Home

Go Home switch can be used to trigger a “go home” without FailSafe. If One-Key

Go Home is enabled during flying, you no longer have control of the aircraft, the LED

blinks in its Control Mode. If One-Key Go Home is disabled, you regain the control at

once. If already in a FailSafe condition, then the switch will not work.

FailSafe and Go Home procedures

1 Record Home Point (HP)

2 Confirm Home Point

3 Transmitter Signal Lost

5Go Home(20m can be customized)4 Signal Lost Lasts 3secs.

Height over HP<=20m

Height over HP>20m

6 Landing after Hovering 15secs

20m

Elevate to 20m

LED LED LED

<8m

≥7

(∝)

(6)

(∝)

(∝) (∝)

(∝)

(1) The aircraft will not go home (only attitude stabilizing) in the condition that <6 or GPS is not

working, even if Transmitter signal is lost or Go Home switch is triggered.

(2) It is recommended to set the Go Home switch in the Assistant software. Users are suggested to

enter FailSafe and go home by using the Go Home switch rather than turning off the Transmitter

in emergency situations.