Owner's Manual
Table Of Contents
- User Manual
- Using This Manual
- Legends
- Read Before First Usage
- Video Tutorials
- Download the DJI Assistant 2
- Product Profile
- Introduction
- At a Glance
- Installation and Wearing
- Usage
- Operating Control
- Connection
- Screen
- Viewing Photos and Videos
- Charging the Goggles RE
- Upgrading Firmware
- DJI Assistant 2
- DJI GO 4 App
- Cleaning and Maintenance
- Cleaning the Goggles RE
- Maintenance of Lenses
- Quick Start Guide
- In the Box
- Disclaimer & Safety Guidelines
Check the Battery Level and Charging
~
®
@:00:0
~
,,,
Low e-Baltely
Level+
High
Press once to check the battery level.
Press once, then again and hold to turn on/off.
8-------U-------@
Power Outlet
100-240V
USB
Charger
Micro USB Port
The Battery
is
fully
charged
when the Charging Status Indicator
or
the Battery
Level Indicators turn off.
Charge time: - 4 hours Maximum run-time: ~ 6 hours
Module Connections
When using with third-party racing drones, you can choose between either analog or digital
video transmission. Please follow the instructions below for installation and connection.
Skip
this
section
if
you
plan
on
using
the
goggles
with
a
dedicated
OJI
drone.
Analog
Video
Transmission
Install the Pagoda antenna (SMA interface) to the SMA Port
of
OJI
Goggles
RE
directly.
-~-
·\/·
A
• The analog frequency band is 5.650 GHz - 5.925 GHz,
of
which 5.725
GHz
- 5.850
GHz
are ISM frequency
bands. You
may
use
these frequencies without permission
but
please follow local regulatory procedures
when using
the
other frequency bands.
•
The
Pagoda
antenna
is
an
omnidirectional left
hand
circularly
polarized
(LHCP)
antenna
design.
It
is
recommended
to
use
the
Pagoda
antenna
or
other
left
hand
circularly
polarized
antennas
for
analog
transmitters
to
get
the
best
transmission performance.
• In a multi-aircraft flying environment,
the
adjacent frequency Interval should
be
higher than
25
MHz
to
avoid
the
live view
of
your DJI Goggles
RE
being
affected
by
a nearby frequency
7