User Manual- M100

DJI MATRICE 100

User Manual

Remove the propellers before upgrading the rmware to prevent injuries.

DO NOT start the motors or touch the motors when upgrading.

The remote controller may become unlinked from the aircraft after upgrading the

rmware. Re-link if necessary.

It is normal for the aircraft to make sounds or ash its LEDs when upgrading to indicate

the upgrade status.

Your Micro SD card should only contain one rmware update package.

Storage devices must be formatted with the FAT32 or exFAT le system.

Upgrading the Remote Controller Firmware

The System Status bar in the DJI GO app (center top of the camera view screen) will ash several

times if a rmware upgrade is available.

Step 1- Check your devices

Make sure:

Remote controller has at least a 50% charge..

Mobile device is connected to the internet.

Mobile device has 30 MB of free space.

Step 2- Run the upgrade

1. Launch DJI GO and tap through “Camera View > System Status Bar > Overall Status”.

2. Tap “Download Firmware” to download the package and upgrade the rmware.

If the rmware upgrade fails, check the connection between the remote controller and your mobile

device, and then try again. Contact DJI Support if the problem persists.

(http://www.dji.com/support)

DO NOT perform rmware upgrades when the aircraft is airborne.

The remote controller may become unlinked from the aircraft after upgrading the

rmware. Re-link if necessary.

Ensure that your internet connection is stable before downloading the package.