User Manual- M100
©
2016 DJI. All Rights Reserved.
57
DJI MATRICE 100
User Manual
2. Flying in a new location, or a location that is different from your last ight.
3. The mechanical structure of the Matrice 100 is changed, i.e. the mounting position of the GPS
module is changed.
4. Severe drifting occurs in ight, i.e. the Matrice 100 has difculty ying in a straight line.
Auto Takeoff and Auto Landing
Auto Takeoff
Use Auto Takeoff to take off your aircraft automatically if the Aircraft Status Indicator is ashing green.
Follow the steps below to use Auto Takeoff:
1. Launch the DJI GO app and enter the Camera View.
2. Ensure that the aircraft is in P-Mode.
3. Go through the pre-ight checklist.
4. Tap and slide Conrm to take off.
5. The aircraft will take off and hover 1.2 meters above the ground.
Auto Landing
Use Auto Landing to land your aircraft automatically if the Aircraft Status Indicator is ashing green.
Follow the steps below to use Auto Landing:
1. Ensure that the aircraft is in P-Mode.
2. Check that the landing area is clear before tapping to land the aircraft.
3. The aircraft will begin to land automatically.
Starting and Stopping the Motors
The Combination Stick Command (CSC) listed below is used to start/stop the motors. Ensure you
perform the CSC in one continuous motion.
Starting the Motors
Perform the CSC command. The motors will begin to speed at an idle speed, with the aircraft
remaining stationary.
Stopping the Motors
There are two methods to stop the motors.
Method 1: When the Matrice 100 has landed, push the throttle stick down, then perform the CSC
command to stop the motors. Release both sticks once the motors have stopped.
Method 2: When the aircraft has landed, push the throttle down and hold. The motors will stop after 3
seconds.
OR