User Manual- M100

DJI MATRICE 100

User Manual

3. Connect the three motor cables of each motor (M1 - M4) to the ports of its corresponding ESC. Be

sure to match the color of the cables and ports.

4. Connect the LED cable of each frame arm to the port of its corresponding ESC.

6. Ensure the motor cables, LED cable, and antenna cable of each frame arm are correctly installed

to their corresponding ports.

Be sure to match the color of each motor cable with its corresponding port. Wrong connections

can cause the motor to rotate in the wrong direction.

After connecting the antenna cables, tighten the cable tie to prevent the cables from

coming loose.

M2 M1

M4M3

M1 - M4 Mark

LED Cable

Motor Cable

LED Port

Color Mark

Antenna ports on the bottom of

the ight controller

M2 M4 M3 M1

7. Double check the positions of the frame arms.

Frame arms M1 and M2 form the front of the

aircraft, while frame arms M3 and M4 form its

rear. Seen from the top, motors on frame arms

M1 and M3 should rotate counter clockwise,

while motors on frame arms M2 and M4

should rotate clockwise.

Cable Tie

Antenna Cable

Antenna Port

5. Pull the antenna cable of each frame arm through the cable tie on the lower plate of the center

frame, and then connect each cable to its corresponding antenna port on the bottom of the ight

controller (You may require some tools for this step). Note the arrangement of the antenna ports

shown below.