Installation Guide

DJI M100

ZENMUSE X5 Series Gimbal Installation Kit

Mounting the Battery Compartment

1. Mount the battery compartment (with the metal terminals facing the tail of the aircraft) onto

the upper plate’s mounting rails. Adjust the aircraft’s center of gravity by moving the battery

compartment along the mounting rails and then tightening the four screws (M2.5x5).

2. Connect the Aircraft Status Indicator cable to the 6-pin port.

3. Connect the Flight Controller's power and signal cables to the 4-pin and 6-pin ports respectively.

4. Connect the lower plate’s CAN cable to the CAN1 port.

CAN1 Port (5-pin)

Aircraft Status Indicator

Cable Port (6-pin)

Port for the Flight Controller

Signal Cable (6-pin)

Port for the Flight Controller

Power Cable (4-pin)

The 6-Pin port with a yellow sticker is reserved. DO NOT connect any cables to this port.

Pull the above cables through the opening behind the battery cover, towards the nose of

the aircraft, before connecting them.