Owner's Manual

4
©
2021 Ryze Tech. All Rights Reserved.
ip x
Roll in the x direction.
l = (left)
r =(right)
f = (forward)
b = (back)
ok / error
go x y z speed
Fly to the coordinates (x,y,z) at the set speed (cm/s).
x: -500 - 500
y: -500 - 500
z: -500 - 500
speed: 10-100 (cm/s)
x, y, and z cannot be between -20 and 20 at the same
time
ok/error + error
status
stop Stop moving and hover immediately. ok / error
curve x1 y1 z1 x2 y2
z2 speed
Fly in a curve from (x1,y1,z1) to (x2,y2,z2) at the set
speed (cm/s).
If the radius of the curve is not within 0.5-10 meters,
the corresponding reminder will be returned.
x1, x2: -500 - 500
y1, y2: -500 - 500
z1, z2: -500 - 500
speed: 10-60
x, y, and z cannot be between -20 and 20 at the same
time
ok/error + error
status
go x y z speed mid
Fly to the coordinate point (x, y, z) in the coordinate
system of the mission pad with the specied ID at the
set speed (m/s)(*Note 2).
x: -500 - 500
y: -500 - 500
z: 0 - 500
speed: 10-100 (cm/s)
x, y, and z cannot be between -20 and 20 at the same
time
curve x1 y1 z1 x2 y2
z2 speed mid
Fly in a curve from point (x1,y1,z1) to point (x2,y2,z2)
in the coordinate system of the mission pad with the
set mid at the set speed (cm/s).
If the radius of the curve is not within 0.5-10 meters,
the corresponding reminder will be returned.
x1, x2: -500 - 500
y1, y2: -500 - 500
z1, z2: 0 - 500
speed: 10-60
x, y, and z cannot be between -20 and 20 at the same
time
jump x y z speed yaw
mid1 mid2
Tello ies to the point (x,y,z) in the mid1 coordinate
system and hovers. Then, it identies the mission pad
of mid2 and rotates to the position (0,0,z) in the mid2
coordinate system to set the yaw value (z>0).
reboot Reboot the drone.
No response
(success)/error