Owner's Manual
Table Of Contents
- Tello Talent
- User Manual
- Quick Start Guide
- Disclaimer and Safety Guidelines
- Safety at a Glance
- Glossary
- Before You Begin
- Disclaimer and Warning
- Pre-Flight Checklist
- Individual Parts
- Regarding Genuine and Functional Parts
- Camera
- Propulsion System
- Flight Batteries
- Tello App
- Firmware
- Product Care
- Flight Condition Requirements
- Weather Conditions and Surrounding Environment
- Interference with Communications
- Operating the Aircraft Responsibly
- Flight Modes, Functions, and Warnings
- Flight Modes
- Low Battery
- Vision Positioning System
- Bounce Mode and 8D Flips
- EZ Shots
- Compliance with Regulations & Flight Limits
- Regulations
- Mission Pad and Flight Map User Guide
- SDK 3.0 User Guide
©
2021 Ryze Tech. All Rights Reserved.
7
Flight Map Coordinate System
The ight map pattern contains a three-dimensional coordinate system, where the origin is at the
center and the ight map is a plane described by an x-axis and y-axis.
Y
X
Operations
The ight maps only work with TT or Tello EDU drones that support SDK 3.0 or later versions.
1. Flight map placement
Lay the ight map on a level surface and adjust the orientation of the DJI logo as needed.
2. Enable TT mission pad detection
• Place TT in the center of the flight map and enter the SDK mode (refer to the Tello SDK
instructions for details).
• After entering SDK mode, enable the mission pad detection function of TT with the "mon" command.
• Enable forward or downward-looking mission pad detection with the "mdirection x" command
as needed.
3. Have TT recognize the ight map
Command the TT to take off and hover. Instruct Tello to recognize the ight map using the mid
parameter in the SDK and perform corresponding ight actions based on the coordinates and ID
information.
Command Descriptions
The ight map commands are the same as those of the mission pad. Note that the ID of the ight
map is 12.
Effective flight map recognition range
Recognizable height range: 0.9 – 2.0 m
Recognizable horizontal range: The effective programming range is 2.8 m×2.8 m
When the ight map is used, the instructions for using mission pads must also be followed.
Do not place small mission pads and other obstructions directly on the ight map to avoid
interference with ight map recognition by the downward-looking camera.
During formation ight, do not have one drone to y directly under another drone, as this
may block the recognition of the ight map. When planning the formation ight path, you
need to appropriately plan the routes of each drone to avoid collisions, which may cause
explosions.