Owner's Manual
Table Of Contents
- Tello Talent
- User Manual
- Quick Start Guide
- Disclaimer and Safety Guidelines
- Safety at a Glance
- Glossary
- Before You Begin
- Disclaimer and Warning
- Pre-Flight Checklist
- Individual Parts
- Regarding Genuine and Functional Parts
- Camera
- Propulsion System
- Flight Batteries
- Tello App
- Firmware
- Product Care
- Flight Condition Requirements
- Weather Conditions and Surrounding Environment
- Interference with Communications
- Operating the Aircraft Responsibly
- Flight Modes, Functions, and Warnings
- Flight Modes
- Low Battery
- Vision Positioning System
- Bounce Mode and 8D Flips
- EZ Shots
- Compliance with Regulations & Flight Limits
- Regulations
- Mission Pad and Flight Map User Guide
- SDK 3.0 User Guide
2
©
2021 Ryze Tech. All Rights Reserved.
Introduction
Mission pads and ight maps are accessories used for programming the RoboMaster TT (Tello Talent):
The vision sensor of the drone detects the IDs of different mission pads and returns the relevant three-
dimensional coordinates in order to execute the corresponding programming commands.
TT comes standard with four mission pads with different patterns on the front and back, for a total of
eight IDs. The patterns on mission pad consist of three parts: a small rocket, the mission pad ID, and
planets.
Small rocket: This represents the positive direction of the x-axis in the mission pad coordinate system.
Mission pad ID: The pads are numbered 1-8, allowing users to distinguish between different mission
pads.
Planets: TT recognizes the ID of the mission pad by detecting the arrangement of the planets and
obtains the coordinate values in the coordinate system of the mission pad.
TT supports 3x3 m and 5x5 m ight maps, which can be regarded as large mission pads used in
the same way with the flight maps, TT can perform single-drone fixed-point flight and multi-drone
formation flight. The pattern of the flight map is composed of DJI Logo, decorative pattern, and
planets.
Small rocket
Mission pad ID
Planets
Decorative
pattern
Small planets
DJI Logo
DJI Logo
Small planets
Decorative
pattern
DJI logo: This represents the positive direction of the x-axis in the mission pad coordinate system.
Decorative pattern: For decoration.
Planets: TT recognizes the ID of the fight map by detecting the arrangement of the planets and
obtains the coordinate values in the coordinate system of the ight map.
Download and print the source files of the flight maps or purchase them from a dealer. Note that
the maps must be printed on matte, textured, rough, and non-reflective material so they can be
recognized by the vision sensor of the drone.
Download the source les of ight maps at: https://www.dji.com/robomaster-tt/downloads