User Manual
Table Of Contents
30
DJI RS 2 User Manual
Operation Modes
There are four operation modes for the DJI RS 2: Upright mode, Underslung mode, and
Flashlight mode.
3D Roll 360 is available when using DJI RS 2 in Flashlight mode. The slip-ring on the
pan axis enables DJI RS 2 to perform a continuous roll rotation. 3D Roll 360 can be
used with the grip at any orientation.
To use 3D Roll 360, press the M button three times to enter or exit 3D Roll 360, or go
to the User Prole page of Ronin app to enable 3D Roll 360. Push the joystick to the
left or right to begin 3D Roll 360. Push the joystick to the left or right twice in quick
succession to trigger auto rotation.
During auto rotation: when the grip is horizontal, press the trigger twice and the camera
will stop in an upright position. Press the trigger three times and the camera will stop
in an upside-down position. When the grip is vertical, press the trigger twice and the
camera will stop at a pan axis angle of 0° with the lens pointing upward. Press the
trigger three times and the camera will stop at a pan axis angle of 180° degree with
lens pointing upward.
Drag a box around the subject you want to track. The gimbal begins to track after
recognizing the subject successfully. The appropriate speed should be set by adjusting
the speed bar on the bottom of the screen when using ActiveTrack. Subjects may be
lost if the speed is set too high and the stabilization may be aected if the speed is set
too low.
Tap
to use Virtual Joystick and Force Mobile.
Refer to the DJI Ronin RavenEye Image Transmission System User Guide for more
information.
Flashlight ModeUnderslung ModeUpright Mode