User Manual

Product Profile

Mavic Pro

User Manual

Preparing the Remote Controller

1. Unfold the mobile device clamps and the antennas.

2. Choose an appropriate RC cable based on the type of mobile device used. An RC cable with a

Lightning Connector has been connected and the Standard Micro USB connector cable and the USB

Type-C connector cable are included. An optional Reverse Micro USB connector cable is available.

Insert the mobile device and secure it.

Unfold the front arms and the propellers before the rear ones. All arms and propellers must be

unfolded before powering on the aircraft, or it may affect Self Diagnostic Testing.

Ensure the Control Mode Switch is toggled to "RC" when using the Remote Controller to control

the aircraft.

You can also connect your mobile device to the remote controller using a USB cable. Plug one end

of the cable into your mobile device and the other end into the USB port on the bottom of the remote

controller. Ensure to disconnect the RC cable from the Micro USB port on the remote controller when

using a USB cable.

Marked Unmarked

Unfold the Arms

1. Unfold the front arms, followed by the rear arms of the aircraft as shown.

2. Unfold all propeller blades.

Refer to the gure below for how to replace the RC cable

The RC cable slider must be replaced if using an USB

Type-C RC cable.

Micro USB Connector

Reverse Micro USB

Connector

Lightning Connector

USB Type-C Connector