User Manual
Table Of Contents
Flight
50
©
 2016 DJI. All Rights Reserved. 
Phantom 4
User Manual
GPS Signal Strong     Blinking Green 
Zone  Restriction DJI GO app Prompt 
Aircraft 
Status 
Indicator
 No-y Zone
Motors will not start.
Warning: You are in a No-fly 
zone. Take off prohibited.
Red ashing
If the aircraft enters the 
restricted area in A-mode, but is 
switched to P-mode, the aircraft 
will automatically descend, land, 
and stop its motors. 
Warning: You are in a no-y zone. 
Automatic landing has begun. 
Restricted-
altitude ight 
zone
If the aircraft enters the restricted 
area in A-mode, but is switched 
to P-mode, it will descend to an 
appropriate altitude and hover 
15 feet below the altitude limit.
R1: Warning: You are in a 
restricted zone. Descending to 
safe altitude. 
R2: Warning: You are in a 
restricted zone. Maximum ight 
altitude is restricted to between 
20m and 500m. Fly cautiously.
Warning zone
No ight restriction applies, but 
there will be a warning .
Warning: You are approaching a 
restricted zone, Fly cautiously.
Free zone
No restrictions. None. None.
Preight Checklist
1.  Remote controller, Intelligent Flight Battery, and mobile device are fully charged.
2.  Propellers are mounted correctly and rmly.
3.  Micro SD card has been inserted, if necessary.
4.  Gimbal is functioning normally.
5.  Motors can start and are functioning normally.
6.  The DJI GO app is successfully connected to the aircraft.
7. Ensure that the sensors for the Obstacle Sensing System are clean.
Semi-automatic descent: All stick commands are available except the left stick command during 
the descent and landing process. Motors will stop automatically after landing. 
 When ying in a safety zone, the aircraft's status indicator will blink red rapidly and continue for 
3 seconds, then switch to indicate current ying status and continue for 5 seconds at which 
point it will switch back to blinking red.
 For safety reasons, please do not y close to airports, highways, railway stations, railway lines, 
city centers, or other sensitive areas. Fly the aircraft only within your line of sight. 










