User Manual

32
©
2014 DJI. All Rights Reserved.
Remote Controllers
INSPIRE 1 User Manual
Status LED Alarm Remote Controller Status
— Solid Red None
The remote controller set as "Master" but it is not
connected with the aircraft.
— Solid Green None
The remote controller set as "Master" and it is connected
with the aircraft.
— Solid Purple None
The remote controller set as "Slave" but it is not
connected with the aircraft.
— Solid Blue None
The remote controller set as "Slave" and it is connected
with the aircraft.
Slow Blinking Red B-B-B…… Remote controller error.
/
Red and Green/ Red and
Yellow Alternate Blinks
None HD Downlink is disrupted.
RTH LED Sound Remote Controller Status.
Blinking White
B…… Sending Return to Home command to the aircraft.
BB…… Aircraft Return to Home in progress.
— Solid White BBB--BB Aircraft is returning home.
The Remote Status Indicator will blink red, sound an alert, when the battery level is critically low.
Linking the Remote Controller
The remote controller is linked to your aircraft before delivery. Linking is only required when using a new
remote controller for the rst time. Follow these steps to link a new remote controller:
1. Power on the remote controller and connect to the mobile device. Launch DJI Pilot app.
2. Power on the Intelligent Flight Battery.
3. Enter “Camera” view and tap on and then tap “Linking Remote Controller” button as shown below.
RC Control Setting
Remote Control Calibration
Stick Mode
Gimbal Pitch/YawC1 C2 Reset gimbal yaw
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
You can customize the C1 and C2 buttons on the back
of the remote controller.
Linking Remote Controller