User Manual

©
2014 DJI. All Rights Reserved.
15
Aircraft
INSPIRE 1 User Manual
Aircraft cannot avoid obstruction during the Failsafe RTH, therefore it is important to set an
reasonable Failsafe altitude before each ight. Launch the DJI Pilot app and enter “Camera”
view and select “MODE” to set the Failsafe altitude.
Failsafe RTH
Failsafe RTH is activated automatically if remote controller signal (including video relay signal) is lost for
more than 3 seconds provided that Home Point has been successfully recorded and compass is working
normally. Return home process may be interrupted and the operator can regain control over the aircraft if
a remote controller signal is resumed.
Failsafe Illustration
When the critical battery level warning activates and the aircraft is descending to land
automatically, you may push the throttle upward to hover the aircraft and navigate it to a more
appropriate location for landing.
Color zones and markers on the battery level indicator reect estimated remaining ight time
and are adjusted automatically, according to the aircraft’s current status.
5 Go Home(20m can be set)
Fast Blinking Yellow
1 Record Home Point (HP)
Blinking Green
3 Remote Controller Signal Lost
Fast Blinking Yellow
2 Conrm Home Point
Blinking Green
6 Landing after Hovering 15secs
Fast Blinking Yellow
4 Signal Lost Lasts 3secs.
Fast Blinking Yellow
Height over HP>20m
Elevate to 20m
Height over HP<=20m
20m
<8m
GPS
Dynamic Home Point
Dynamic home point is useful in situations when you are in motion and require a Home Point that is
different from the takeoff point. GPS module is located at the position shown in the gure below:
Ensure the space above the GPS module is not obstructed when using Dynamic Home Point.