User Manual

14
©
2018 DJI All Rights Reserved.
Mavic Air
User Manual
Warning
Aircraft Status
Indicator
DJI GO 4 App
Remote
Controller
Remarks/Instructions
Low Battery
Level
Blinks red slowly
Tap “Go-home” to have
the aircraft return to the
Home Point automatically
or “Cancel” to resume
normal ight. If no action
is taken, the aircraft will
automatically y home after
10 seconds.
Alarm sounds
continuously
Battery level is low. Fly
the aircraft back and land
promptly, then stop the
motors and replace the
battery.
Critically Low
Battery Level
Blinks red quickly Display ashes red Alarm sounds
continuously
The aircraft will descend
and land automatically.
This procedure cannot be
cancelled. If there is danger
of collision occurring, push
the throttle up and try to
navigate away.
Failsafe RTH
The Forward Vision System allows the aircraft to create a real-time map of its ight route as it ies. If the
Home Point was successfully recorded and the compass is functioning normally, Failsafe RTH will be
automatically activated if the remote control signal is lost for a specied amount of time (three seconds
when using the remote controller and 20 seconds when ying with a mobile device). When Failsafe RTH
is activated, the aircraft will retrace its original ight route home.
If the wireless control signal is re-established during the Failsafe RTH procedure, the aircraft will hover at
its present location for 10 seconds and wait for pilot commands. The user may pull the control sticks to
cancel Failsafe RTH and retake control. If no pilot command is given the aircraft will resume its ight home.
1 Record Home Point 2 Conrming Home Point
4 Signal Lost for Extended Time
×
5 RTH (adjustable altitude)
Height over HP > Failsafe Altitude
Elevate to Failsafe Altitude
Height over HP<=Failsafe Altitude
Failsafe Altitude
×
6 Landing
×
3 Remote Controller Signal Lost
×
RTH and Battery Level Warnings
If a battery level warning appears, take action as described in the table below.