Use and Care Manual

Spark

User Manual

61%

09:29

2.4G

In flight (GPS)

P-GPS

The Wi-Fi frequency of your mobile device can be set to 2.4 GHz (default) or 5.8 GHz. On

supported devices, set Wi-Fi to 5.8 GHz for less interference.

Press and hold the power button for nine seconds or more until you hear three beeps to reset

the Wi-Fi name and password, and reset the Wi-Fi frequency to 2.4 GHz. Or tap “Help” in the

DJI GO 4 app, then follow the instructions.

Only fly with a Wi-Fi connection in wide open areas with relatively little electromagnetic

interference. If your connection is adversely affected by interference, it is recommend to y

with the remote controller instead, or move to an area with less interference.

Using Virtual Joysticks

Ensure the mobile device has been connected to the aircraft before using the virtual joysticks. The

illustrations below are based on Mode 2 (left stick as throttle).

Virtual Joysticks GUI

Move the aircraft upwards, downwards, left, or right by pressing on the left half of the screen. Move the

aircraft forwards, backwards, or laterally by pressing on the right half of the screen.

Tap on the " " button to enable or disable the virtual joysticks..

The area beyond the white cycles is also responsive to control commands.

Controlling the Aircraft with a Mobile Device

You can connect a mobile device via Wi-Fi to control the aircraft with DJI GO 4. Follow the instructions

below to learn how.

1. Power on the aircraft.

2. Turn on your mobile device's Wi-Fi, select Spark’s network, and enter the Wi-Fi password.

3. Launch DJI GO 4. Tap “GO FLY” to enter camera view.

4. Tap the icon to take off automatically. Put both your thumbs on screen and use virtual joysticks to

maneuver the aircraft.

Camera Data Port

Turn on Spark and connect a USB cable to the Micro USB Port to download photos and videos to your

computer.

The aircraft must be turned on before attempting to access les on the Micro SD card.