User Manual

Flight
Phantom 4 Pro / Pro+ User Manual
©
2016 DJI All Rights Reserved.
59
Stopping the Motors
There are two methods to stop the motors.
Method 1: When Phantom 4 Pro / Pro+ has landed, push the left stick down , then conduct the same
CSC that was used to start the motors, as described above . Motors will stop immediately. Release both
sticks once motors stop.
Method 2: When the aircraft has landed, push and hold the left stick down. The motors will stop after three
seconds.
OR
Method 1 Method 2
Stop the Motor Mid-ight
Pull the left stick to the bottom inside corners and press the RTH button at the same time.
Only stop the
motors mid-ight in emergency situations when doing so can reduce the risk of damage or injury.
OR
Starting/Stopping the Motors
Starting the Motors
A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors have started spinning, release both sticks
simultaneously.