User Manual

©
2022 DJI All Rights Reserved.
43
DJI Mini 3 Pro
User Manual
Remote Controller Alert
The remote controller beeps when there is an error or warning. Pay attention when prompts appear on
the touch screen or in DJI Fly. Slide down from the top and select Mute to disable all alerts, or slide the
volume bar to 0 to disable some alerts.
The remote controller sounds an alert during RTH. The RTH alert cannot be cancelled. The remote
controller sounds an alert when the battery level of the remote controller is low (6% to 10%). A low
battery level alert can be cancelled by pressing the power button. The critical low battery level alert,
which is triggered when the battery level is less than 5%, cannot be cancelled.
Optimal Transmission Zone
The signal between the aircraft and the remote controller is most reliable when the remote controller is
positioned towards the aircraft as depicted below.
Battery Level LEDs
Blinking Pattern Battery Level
75%~100%
50%~75%
25%~50%
0%~25%
DO NOT use other wireless devices operating at the same frequency as the remote controller.
Otherwise, the remote controller will experience interference.
A prompt will be displayed in DJI Fly if the transmission signal is weak during ight. Adjust the remote
controller orientation to make sure that the aircraft is in the optimal transmission range.
Linking the Remote Controller
The remote controller is already linked to the aircraft when purchased together as a combo. Otherwise,
follow the steps below to link the remote controller and the aircraft after activation.
Method 1: Using the Combination Buttons
1. Power on the aircraft and the remote controller.
2. Press the C1, C2, and Record buttons simultaneously until the status LED blinks blue and the
remote controller beeps.
3. Press and hold the power button on the aircraft for more than four seconds. The aircraft will beep