Mini 3 Pro - Safety Guidelines (DJI RC) v1.0
15
Compliance Information
FCC Compliance Notice
Supplier’s Declaration of Conformity
Product name: DJI Mini 3 Pro
Model Number: MT3M3VD; RM330
Responsible Party: DJI Technology, Inc.
Responsible Party Address: 201 S. Victory Blvd., Burbank, CA 91502
Website: www.dji.com
We, DJI Technology, Inc., being the responsible party, declares that the above mentioned model was
tested to demonstrate complying with all applicable FCC rules and regulations.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Anychangesor modicationsnotexpresslyapprovedbythepartyresponsibleforcompliancecouldvoid
theuser’sauthoritytooperatetheequipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
canbedeterminedbyturningtheequipmentoandon,theuserisencouragedtotrytocorrectthe
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
—Connecttheequipmentintoanoutletonacircuitdierentfromthattowhichthereceiverisconnected.
— Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information
The aircraft complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order
to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the
antenna shall not be less than 20cm during normal operation. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
This remote controller complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying RF exposure
compliance. This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the
Federal Communications Commission (USA). These requirements set a SAR limit of 1.6 W/kg averaged
overonegramoftissue.ThehighestSARvaluereportedunderthisstandardduringproductcerticationfor
use when properly worn on the body.
ISED Compliance Notice
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
EconomicDevelopmentCanada’slicence-exemptRSS(s).Operationissubjecttothefollowingtwo
conditions: (1)This device may not cause interference.(2)This device must accept any interference, including
interference that may cause undesired operation of the device.
L’émetteur/récepteurexemptdelicencecontenudans leprésentappareilestconformeauxCNR
d’Innovation,SciencesetDéveloppementéconomiqueCanadaapplicablesauxappareilsradioexempts
delicence.L’exploitationest autoriséeauxdeuxconditionssuivantes:(1)L’appareilnedoitpasproduire
debrouillage;(2)L’appareildoitaccepter toutbrouillageradioélectriquesubi,mêmesilebrouillageest
susceptibled’encompromettrelefonctionnement.
ThisequipmentcomplieswithRSS‐102radiationexposurelimitssetforthforanuncontrolledenvironment.
This equipment should be installed and operated with minimum distance 20cm between the radiator and
your body. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Cetéquipementestconformeauxlimitesd'expositionauxradiationsCNR‐102établiespourun
environnementnoncontrôlé.Cetéquipementdoitêtreinstalléetutiliséavecunedistanceminimalede20
cm entre le radiateur et votre corps.










