User's Manual

Table Of Contents

DJI Air 2S User Manual

DO NOT charge an Intelligent Flight Battery immediately after ight as the temperature may be too

high. Wait until it cools down to room temperature before charging again.

The charger stops charging the battery if the battery cell temperature is not within the operating

range of 41° to 104° F (5° to 40° C). The ideal charging temperature is 71.6° to 82.4° F (22° to 28° C).

The Battery Charging Hub (not included) can charge up to three batteries. Visit the ocial DJI Online

Store for more information.

Fully charge the battery at least once every three months to maintain battery health.

DJI does not take any responsibility for damage caused by third-party chargers.

It is recommended to discharge the Intelligent Flight Batteries to 30% or lower before transportation.

This can be done by ying the aircraft outdoors until there is less than 30% charge left.

fully charge the battery before takeo.

2. Batteries cannot be used in extremely low-temperature environments of lower than 14° F (-10° C).

3. When in low-temperature environments, end the ight as soon as DJI Fly displays the low battery

level warning.

4. To ensure the optimal performance of the battery, keep the battery temperature above 68° F (20° C).

5. The reduced battery capacity in low-temperature environments reduces the wind speed resistance

performance of the aircraft. Fly with caution.

6. Fly with extra caution at high sea levels.

Charging the Battery

Fully charge the Intelligent Flight Battery before every ight using the provided DJI charger.

1. Connect the AC power adapter to an AC power supply (100-240 V, 50/60 Hz).

2. Attach the Intelligent Flight Battery to the AC power adapter using the battery charging cable with

the battery powered o.

3. The battery level LEDs display the current battery level during charging.

4. The Intelligent Flight Battery is fully charged when all the battery level LEDs are off. Detach the

charger when the battery is fully charged.

The table below shows the battery level during charging.

LED1 LED2 LED3 LED4

Battery Level

0% < Battery Level ≤ 50%

50% < Battery Level ≤ 75%

75% < Battery Level < 100%

Fully Charged