Owner's Manual

Mavic Air 2 User Manual
©
2020 DJI All Rights Reserved.
27
Battery Protection Mechanisms
The battery LED indicator can display battery protection indications triggered by abnormal charging conditions.
LED1 LED2 LED3 LED4 Battery Level
0%
<
Battery Level ≤ 50%
50%
<
Battery Level ≤ 75%
75%
<
Battery Level
<
100%
Fully Charged
The table below shows the battery level during charging.
Battery Protection Mechanisms
LED1 LED2 LED3 LED4 Blinking Pattern Status
LED2 blinks twice per second Overcurrent detected
LED2 blinks three times per second Short circuit detected
LED3 blinks twice per second Overcharge detected
LED3 blinks three times per second Over-voltage charger detected
LED4 blinks twice per second Charging temperature is too low
LED4 blinks three times per second Charging temperature is too high
If the battery protection mechanisms activate, in order to resume charging it is necessary to unplug the battery
from the charger, and then plug it in again. If the charging temperature is abnormal, wait for the charging
temperature to return to normal, and the battery will automatically resume charging without requiring to unplug
and plug in the charger again.
Inserting the Intelligent Flight Battery
Insert the Intelligent Flight Battery into the battery compartment of the aircraft. Make sure it is mounted securely
and that the battery buckles are clicked into place.
Removing the Intelligent Flight Battery
Press the battery buckles on the sides of the Intelligent Flight Battery to remove it from the compartment.
DO NOT detach the battery when the aircraft is powering on.
Make sure that the battery is mounted firmly.
Click