Owner's Manual
Compliance Information
FCC
Compliance
Notice
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause
undesired operation.
Any changes
or
modifications not expressly approved
by
the
party responsible for compliance could void the user's authority to
operate the equipment.
This equipment has been tested
and
found to comply with the
limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are
designed
to provide reasonable
protection against harmful interference
in
a residential installation
This
equipment
generates,
uses
and
can
radiate
radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio
or
television reception, which
can be determined
by
turning the equipment off and
on,
the user
is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that
to
which the receiver is connected
- Consult the dealer or an experienced radio/TV technician
for
help.
This
equipment
complies
with FCC radiation exposure limits
set forth for an uncontrolled environment. End user must follow
the
specific
operating instructions for satisfying
RF
exposure
compliance. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
ISED
Compliance Notice
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with lnnovatoo, Science and Economic Development
Canada's licence-exempt RSS(s). Operation is subject to the
following
two
conditions.
(1)Th1s
device may not cause interference.
(2)This device must accept any Interference, including interference
that may cause undesired operation of the device.
so