Owner's Manual
Compliance Information
FCC Compliance
Notice
This
device
complies
with Part
15
of the FCC Rules Operation
is
sub1ect to the following
two
conditions: (1) This device
may
not cause harmful interference,
and
(2) This device must
accept
any interference received, including interference that may cause undesired operation.
Any
changes
or modifications not expressly approved
by
the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested
and
found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference
,n
a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used
1n
accordance with the instruct,ons,
may
cause
harmful interference to radio communications However, there ,s
no
guarantee that
interference
will
not
occur
in
a
particular
installation
If
this
equipment
does
cause
harmful
interference to radio or television reception,
which
can
be determined
by
turning the equipment
off and on, the user is encouraged to try to correct the interference
by
one or more of the following
measures.
- Reorient or relocate the
rece1v1ng
antenna.
- Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to
which
the receiver
is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
For Remote Controller ,SAR tests are
conducted
using standard operating positions
accepted
by
the FCC with the device transmitting at its highest certified power level in all tested frequency
bands.although the SAR is determined at the highest certified power level, the actual SAR level of
the device while operating can
be
well below the maximum value. Before a new model is a available
for sale to the public, it must
be
tested and certified to the FCC that it does not exceed the exposure
limit established
by
the FCC, Testsfor each
product
are
performed in positions and locations as
required
by
the FCC.
For
body
worn operation. this device has been tested and meets the FCC
RF
exposure guidelines
when used with an accessory designated for this
product
or when used with an accessory that
Contains no metal and that positions the handset a minimum of 10mm from the
body
ISEDWaming
This
device
contains
licence-exempt
transmitter(s)/receiver(s)
that
comply
with Innovation,
Science and Economic Development Canada's licence-exempt RSS(s) Operation
is
sub1ect to the
following two conditions:
(1)Th1s
device may not cause 1nterference.(2)This device must accept any
interference. including Interference that may cause undesired operation of the device
117